EN
11
▪
Cut the long grass into stages using small cuts from the top to the root. (F2).
▪
You will work safer and you will have better results if you keep the machine in the optimal
power area. If the machine starts working slower, reduce the load for a short time.
▪
If an object is hit during mowing, turn off the machine and check it.
ATTENTION: The cutting head continues to rotate for a few seconds after the machine
is turned off.
▪
Put the machine down only after the cutting head has completely stopped.
▪
Check the damage machine for any impact.
▪
Do not use knives, wires or similar devices of shoulder motocos.
▪
Use only accessories recommended by the manufacturer.
▪
Repair the machine only with qualified specialists and only with original parts. This way
you make sure that the safety of the machine is maintained.
Automatic cutting blade
Your machine is equipped with a wire drum.
The thread is blunt while working. To release more wire, turn on the machine and tap the
ground trimmer head.
The wire will be automatically released due to centrifugal force. The wire will be cut to the
correct length by the blade on the guard (load limiter).
Never use the machine without a guard because it also acts as a load limiter.
Drum change
Unplug the machine before changing the drum with wire. Hold the serrated part of the
wire drum with one hand (D) and open the housing by turning it into the open position.
Remove the empty drum by pressing the wire release button (E) and replace it with a
new one.
Introduction of the new drum
Remove approx. 10 cm of drum wire and pass it through the hole on its housing.
