ENG
16
START: For engines equipped with thermal shock
Pull the emergency stop handle with your left hand and stick it to
the guide handle. Grasp the starter handle with your right hand
and pull gently until you feel resistance. Shoot constantly to start
the engine. After the engine has started, let it reach maximum
speed, after which you can start working.
START: For manual shock engines
Start by actuation (demaror): Pull the emergency stop handle with your left hand and stick
it to the guide handle and position the shock lever in the closed position and apply the
throttle lever to the maximum (if equipped). Grasp the starter handle with your right hand
and pull gently until you feel it is resisting, then constantly to start the engine, then position
the shock lever in the open position (working). After the engine has started, let it reach
maximum speed, after which you can use it in progress.
AUTO RUNNING (turnkey):
If the machine is equipped and with automatic start, the start
will be done by actuating the key following the start-up steps depending on the engine
equipment.
8.2 STOP
2) Release the safety brake control lever (engine-stop).
Note: Stop
(for machines equipped with an accelerator lever, the shutdown will be done
after the engine speed is minimized, after which you release the motor-stop safety brake
control handle).
8.3 OPERATION
Careful:
Remove your hands and feet from the active area of the cutting knife.
NOTE:
For better results, raise the cutting position until you determine which
height is better for the machine.
ATTENTION:
The knife continues to rotate for a few seconds after the engine
is stopped.
