RUPTELA FM-Plug 4, User Manual

Page: 5 / 34

4
support@ruptela.com | www.ruptela.com
Main Support no.: +370 5 2045030
Polish Support no.: +48 22 2092532
Ukrainian Support no.: +380 947 107319
2. Introduction
2.1 Purpose
The purpose of this document is to provide physical and technical data of the device, to explain
device’s behavior and how various conditions are indicated. Also, device p reparation for operation and
its configuration instructions are included.
2.2 Acronyms
AC / DC – Alternating Current/Direct Current;
ACK - A signal to acknowledge the receipt of data;
GLONASS – Global Navigation Satellite System;
GNSS – Global Navigation Satellite System;
GPRS – General Packet Radio Service;
GPS – Global Positioning System;
GSM – Global System for Mobile Communications;
IO – Inputs / Outputs;
LED – Light Emitting Diode;
PC – Personal Computer;
PCB – Printed Circuit Board;
SELV – stands for Safety Extra Low Voltage. A SELV circuit is a secondary circuit which is so designed
and protected that under normal and single fault conditions, its voltages do not exceed a safe value.
SMS – Short Message Service;
UMTS – Universal Mobile Telecommunications System;
2.3 Legal Information
Copyright © 201 9 Ruptela. All rights reserved. Reproduction, transfer, distribution or storage of parts
or all of the contents in this document in any form without the prior written permission of Ruptela is
prohibited. Other products and company names mentioned in this document are trademarks or trade
names of their respective owners.
2.4 Safety
All the associated (additional) equipment such as PC’s, batteries, sensors etc., shall meet the
requirements of standard EN60950-1.
Do not disassemble the terminal. If the enclosure of the terminal is damaged, or the
insulation of wires is damaged, first of all disconnect power supply cables from the power
supply source.
All of the wireless data transferring equipment produces interference that may affect other
devices, which are placed nearby.
The terminal can be installed or dismounted only by qualified personnel!
The terminal must be firmly fastened in the predefined location. Predefined location is
described in the mounting instructions.
The programming must be performed using a 2 nd safety class PCs (with an autonomic power
supply).