Runco Reflection CL-810 CineWide, Owner'S Operating Manual

Page: 27 / 58

27
Runco CL-810 Owner’s Operating Manual
Turning on the Power
Basic Operation
LIGHT
OFF ON
VID S-VID COMP1
RGBHD HDMI
COMP2
• Adjust the projected image size with the
ZOOM and arrow buttons on the remote
control. To focus the image, use the
FOCUS and arrow buttons.
Adjusting the Zoom and
Focus
Adjusting the Vertical
Lens Offset
• Turn on the main power switch. The
POWER LED will light orange.
• Press the ON button on the remote
control to turn on the projector. The
POWER LED flashes orange during
the warm up period, then lights solid
green.
• “Searching….” appears on the
screen before the projector identifies
the input signal, and remains there
until a valid signal is detected.
• If an incompatible input signal exceeds
the range of the projector, a “No signal
supported” message will be displayed
on the screen. This message remains
on the screen until you change the
input signal.
• To adjust the projector height or
compensate for a mounting surface that
isn’t level, turn the four adjustable feet
on the bottom of the projector.
Adjusting Projector
Height
PBP PIP PIP+ ACT
FOCUS ZOOM LENS PIP-
PBP PIP PIP+ ACT
FOCUS ZOOM LENS PIP-
• To adjust the vertical image position,
use the LENS and arrow buttons on the
remote control.