16
Connecting the Projector
to a Computer
Connecting with HD15-pin VGA cable.
1
Connect an HD 15-pin VGA cable to the RGB HD input on the projector. Secure
the connectors by tightening the thumbscrews.
2
Connect the VGA cable to the VGA output on the computer. Secure the connectors
by tightening the thumbscrews.
Connection and Setup
�����������������
����������
���������
Note:
• See the “Computer Compatibility Chart” on page 49 for a list of computer signals
compatible with the projector. Use with signals other than those listed may cause
some functions not to work.
• When connecting a computer to the projector’s RGB-HD input, set the source to
RGB-HD from the Source Select menu, or select RGB mode by pressing RGB-HD
on the remote control.
• A Macintosh adaptor may be required for use with some Macintosh computers.
Contact your nearest Authorized service center or dealer.
• Depending on the computer you are using, an image may not be projected unless
the signal output setting of the computer is switched to external output. Refer to the
computer user manual for switching the computer signal output settings.
