Runco PlasmaWall PL-50XA, Owner'S Operating Manual

Page: 28 / 72

Installation
18 Runco PlasmaWall Owner’s Operating Manual
PRE
L
IMINAR
Y
3.3
Installation
Considerations Proper installation of your PlasmaWall will ensure the highest possible picture quality.
Whether you are installing the PlasmaWall temporarily or permanently, you should take the
following into account to ensure that it performs optimally.
Mounting the PlasmaWall
on a Wall or Table Stand
To install the PlasmaWall, you will need either an optional table stand or wall-mounting kit.
The PlasmaWall cannot be installed on its own.
If you do decide to wall-mount the PlasmaWall, ensure that the wall-mount bracket is
installed according to the instructions included with it. The wall must be capable of
supporting a redundant weight factor three (3) times the weight of the display, or be
reinforced.
Runco recommends that this be done by a custom installation specialist.
You can attach your optional mounts or stand to the PlasmaWall in either of two ways:
• While it is upright.
• As it lies flat with the screen face
down. Place the protective sheet,
which was wrapped around the
plasma monitor when it was
packaged, between the screen and
your work surface to avoid
scratching or otherwise damaging
the screen surface.
Ambient Light In general, minimize or eliminate light sources directed at the display. Contrast ratio in your
images will be noticeably reduced if light directly strikes the display, such as when a shaft
of light from a window or floodlight falls on the image. Images may then appear washed
out and less vibrant.
➤
Use only a Runco-approved wall-mount kit or table stand that is
specifically designed for your display.
Note
➤