Runco PlasmaWall PL-50XA, Owner'S Operating Manual

Page: 25 / 72

Runco PlasmaWall Owner’s Operating Manual 15
PRE
L
IMINAR
Y
3.1
Remote Control To install batteries in the remote control:
1. Press down the tab on the cover and
pull the cover in the direction of the
arrow.
2. Insert the included batteries. Ensure
that the polarities correctly match the
and markings inside the battery
compartment.
3. Insert the lower tab of the cover into the
opening, and press down the cover until
it clicks in place.
Notes on Batteries • When installing batteries, make sure that the battery polarities are correct.
• Do not mix an old battery with a new one or different types of batteries.
• If you will not use the remote control for a long time, remove the batteries to avoid
damage from battery leakage.
Notes on Remote Control
Operation The remote control can be used to control the PlasmaWall within the ranges shown in
Figure 3-1.
Figure 3-1. Available Range of the Remote Control
3. Installation
Approx.
7m / 23ft