Runco NLMP22109, Installation & Operation Manual, Page: 21 / 88

Runco VX-22i Installation/Operation Manual 7
PRE
L
IMINAR
Y
5. LEFT BUTTON
Used to direct-select inputs or move the menu cursor left in the OSD. When no menu
is present on-screen, the
LEFT button toggles through the different sources, in this
order:
HDMI 2 - HDMI 1 - HD3 (VGA/Y-Pb-Pr) - HD 2 (BNC) - HD 1 (RCA) - S-Video -
Composite (VID)
6. UP BUTTON
Use to direct-select aspect ratios or move the menu cursor up in the OSD. When no
menu is present on-screen, the
UP button toggles through aspect ratios in the
following order:
16:9 - 4:3 - Letterbox - VirtualWide - Cinema - Virtual Cinema
(Virtual Cinema is available only on CineWide-equipped projectors. For more
information about aspect ratios, refer to Table 4-1.)
7. DOWN BUTTON
Use to direct-select aspect ratios or move the menu cursor down in the OSD. When
no menu is present on-screen, the
DOWN button toggles through the different aspect
ratios, in this order:
Virtual Cinema - Cinema - VirtualWide - Letterbox - 4:3 - 16:9
8. RIGHT BUTTON
Used to direct-select inputs or move the menu cursor right in the OSD. When no
menu is present on-screen, the
RIGHT button toggles through the different sources,
in this order:
Composite (VID) - S-Video - HD 1 (RCA) - HD 2 (BNC) - HD 3 (VGA/Y-Pb-Pr) -
HDMI 1 - HDMI 2
9. S TAND-BY LED
Lights orange to indicate that the projector is in standby mode.
10. S OFT POWER BUTTON
Press once to turn on the VX-22i. Press it again to put the projector into Standby
mode. For a discrete on or off command, you can use the direct access buttons on
the remote control (see Figure 2-4).
11. PATTERN BUTTON
Press PATTERN to access the internal test pattern menu. Use arrow keys to select a
pattern and press S ELECT to confirm. Press PATTERN again to return to the
selected source.
12. POWER INPUT (100 to 240 VAC)
Connect the VX-22i to power here.
13. S ERVICE PORT
For use by authorized service personnel only.
14. S ELECT BUTTON
Press S ELECT to confirm your selection of a highlighted choice on the On-Screen
Display (OSD).
15. MENU BUTTON
Pressing the MENU button brings up the main VX-22i menu. Also, if you are in an
adjustment mode or function, pressing MENU brings the menu back one level.
16. INPUT S
Connect your video sources and other equipment to these inputs. Refer to VX-22i
Rear Connector Panel on page 8.