Runco CX-40HD, User Manual, Page: 64 / 78

Maintenance and Troubleshooting
52 Runco CX-40HD/CX-46HD Owner’s Operating Manual
PRE
L
IMINAR
Y
Picture is okay, but there is no
sound. • Audio output is muted.
• Volume setting is too low.
• Source component is
connected incorrectly or
not at all.
• Speakers are connected
incorrectly or not at all.
• Audio settings are
incorrect.
• Press the MUTE button
on the remote control.
• Turn up the volume.
• Check audio connections
to source component.
• Check speaker
connections (Figure 3-8).
• Check the following
settings: Digital Audio Out
(page 36), TV Speaker
(page 36) and HDMI Audio
(page 41).
Image is too bright and/or
lacks definition in the bright
areas of the image. • Contrast is set too high. • Lower the contrast setting.
Image appears “washed out”
and/or dark areas appear too
bright. • Brightness is set too high. • Lower the brightness
setting.
Black or white dots appear on
all channels or a specific
channel. • Antenna or cable TV
source is connected
incorrectly or not at all.
• Broadcast signal is weak.
• Check the antenna or
cable TV connection.
• If using an off-air antenna,
adjust its position or
location.
Colors in the image are
swapped; for example, reds
appear blue or vice versa. • The Red/Pr, Green/Y or
Blue/Pb outputs from the
source are connected to
the wrong inputs on the
Crystal Series LCD.
• Ensure that the source
outputs are connected to
the correct Crystal Series
LCD input.
RGB-HD images appear
“noisy.” • Clock and Phase settings
need adjustment.
• Manually adjust Clock and
Phase settings, or perform
an Auto-Adjust (refer to
PC
Mode Adjust
on
page 38).
“Out of range” appears
on-screen. • The resolution and
frequency of the video
card in the computer are
not compatible with the
Crystal Series LCD.
• Select a compatible
resolution and vertical
frequency (refer to
Computer Signal
Compatibility
on
page 63).
The image is too large or too
small. • Image size needs
adjusting.
• Adjust the image size (refer
to
PC Mode Adjust
on
page 38).
Poor broadcast sound quality. • The sound quality of a
stereo broadcast may be
unstable in an area with a
weak signal.
• Use the MT S / S AP button
on the remote control to
select mono.
Table 5-1. Trouble s hooting Chart (continued)
S ymptom Po ss ible Cau s e( s ) S olution