Runco CINEWIDETM VX-3000D, Installation & Operation Manual

Page: 69 / 124

Installation
VX-3000d Series Installation/Operation Manual 53
PRE
L
IMINAR
Y
5. Use the Height/Y Adjustment T-Screws/Washers (item #3), Pitch Adjustment
T-Screws/Washers (item #4) and T-Nuts (item #9) to attach the Pitch Adjustment
Yoke and Lens Adapter Ring to the Anamorphic Lens Holder.
The Yoke should be
as close to the primary lens as possible.
6. Attach the lens to the Lens Adapter Ring by threading it clockwise.
Figure 3-24. Attaching the Anamorphic Lens to the Lens Ring
Configure Lens Motor Trigger (VX-3000d/CineWide with AutoScope only):
CineWide with AutoScope maintains constant image height independent of the aspect
ratio, while using the full display resolution of the projector. It accomplishes this by moving
the anamorphic lens in front of the primary lens when widescreen material is being viewed.
When the viewer transitions back to 16:9 or 4:3 source material, the anamorphic lens
moves out of the light path.
To configure the lens motor trigger on the DHD Controller for proper AutoScope
operation:
1. Project a 2.35:1 aspect ratio test pattern or other image on the screen.
2. On the DHD Controller remote control or front panel, press MENU .
3. Select Service from the Main Menu and enter the Service Menu passcode.
Lens threads into ring
FO
CU
S
You must enter a passcode to access the Service menu for the first
time after turning on the system.
Note