1)
Verify that the router switch is off. Connect one end of the supplied power cable to the socket on the rear panel of the
cabinet and the other end to the AC power socket.
2)
Switch the router to power on position.
3)
For the RSR20-14E series router, verify that the PWR indicator on the front panel is on. If so, it indicates that the
power cable is correctly connected.
The power supply socket should be installed near the device for convenient plugging.
Disconnect all pluggable communication networks ends and power distribution system ends before
disconnecting the power cables.
Connecting the Console
Ruijie series routers supply an EIA/TIA-232 configuration console for local configuration. This interface enables user to
complete the local configuration of the routers.
The following table describes the configuration attributes.
Parameters
Description
Connector
RJ-45
Interface Standard
Asynchronous EIA/TIA-232
Baud Rate
Default: 9600 bps
Supported Services
1. Command line interface
2. Connection to the character terminal
To connect the console port of the router:
Connect one end of the supplied configuration cable to the console port of the router and the other end to the DB-9 male
connector used to configure the router. Verify that a Super Terminal is run on the PC.
Installing Line Cards
This section introduces how to install the line card including SIC cards supported by the RSR20-14E series router.
Installing Line Card Modules
1)
Switch off all power supply connected to the router. Otherwise electric shock and device damage may occur.
2)
Face the router rear panel, and remove the blank panel with screwdrivers.
3)
Flush the line card interface board and the edge of the opening of the back panel of the router base.
4)
Push the line card to the router until the interface board closely touches the backplane of the router.
5)
Tighten the fastening screws on the line card.
6)
Repeat Step 3 through Step 5 until all the line cards have been installed.
