Ruijie RG-EG210G-E Series, Hardware Installation And Reference Manual

Page: 7 / 24

Ruijie RG-EG210G-E Series Routers Hardware Installation and Reference Guide Preparation before Installation
2 Preparation before Installation
2.1 Safety Suggestions
To avoid personal injury and equipment damage, please carefully read the safety suggestions before you install the
RG-EG210G-E series router.
The following safety suggestions do not cover all possible dangers.
2.1.1 Installation

Keep the chassis clean and free from any dust.

Do not place the equipment in a walking area.

Do not wear loose clothes or accessories that may be hooked or caught by the device during installation and
maintenance.
2.1.2 Movement

Do not frequently move the device.

When moving the device, note the balance and avoid hurting legs and feet or straining the back.

Before moving the device, turn off all power supplies and dismantle all power modules.
2.1.3 Electricity

Observe local regulations and specifications when performing electric operations. Relevant operators must be
qualified.

Before installing the device, carefully check any potential danger in the surroundings, such as ungrounded power
supply, and damp/wet ground or floor.

Before installing the device, find out the location of the emergency power supply switch in the room. First cut off the
power supply in the case of an accident.

Try to avoid maintaining the switch that is powered-on alone.

Be sure to make a careful check before you shut down the power supply.

Do not place the equipment in a damp location. Do not let any liquid enter the chassis.
Any non-standard and impropriate electric operations may cause an accident such as a fire or electrical shock, thus
causing severe even fatal damage to human bodies and equipment.
Direct or indirect touch through a wet object on high-voltage and commercial electricity may bring a fatal danger.
If a power supply system is equipped with a leakage protector (also referred to as "leakage current switch" or "leakage
current breaker"), the rated leakage action current of each leakage protector is greater than twice of the theoretical
maximum leakage current of all the power supplies in the system. For example, if a system is equipped with eight
identical power supplies, the leakage current of each power supply is equal to or less than 3.5 mA, and the leakage
current of the system totals 56 mA. A leakage protector with 30 mA rated action current supports less than five power