Solid red
Warnings
Double blinking red
Locate AP
Figure 1-2 Bottom View of RG-AP320-I
Note
1. 1000BASE-T/100BASE-TX/10BASE-T auto-sensing PoE-capable Ethernet port
Power Sources
The AP can be powered either with a 48V DC power adapter or through Power over Ethernet (PoE).
The AP requires Ruijie power adapters (If needed, you can buy them from Ruijie).
To use a PoE device, make sure it supports the IEEE 802.3af/at PoE standard.
Cooling Solution
The AP adopts fanless design.
Leave sufficient space at the surrounding of the AP when place the AP to permit airflows for proper
ventilation.
Radiation Pattern
The AP uses internal high-gain antennas that have an adaptive radiation pattern. The antennas automatically adjust
radiation in the direction of wireless clients (see the three kinds of radiation patterns in Figure ). Because the antennas
focus gains in front of the AP, signal strength in the front is stronger. Therefore it is preferable to install the AP towards the
area where wireless coverage is most required.
When mount the AP on a wall or ceiling, install the AP towards where you stand to avoid backward coverage.
