Model LR-26C, LR-623, LR-28A, & LR-2355 Sub-Frame Hoist Installation and Operation Manual
Stock No. 1657499
Page 3 of 25
"WARNINGS"
WARNING:
Installing or operating this hoist without first understanding the proper installation and operation
procedures can lead to serious injury or death. Always read and understand fully all installation
and operation manuals before installing or operating this equipment.
WARNING:
Welding, oxy-fuel cutting, or grinding sparks can cause fuel to ignite that in turn can lead to injury
or death.
Always
take adequate steps to avoid ignition of fuel from fuel tanks when welding,
grinding, or oxy-fuel cutting during equipment installation.
WARNING:
Heat from the truck's exhaust system can cause hydraulic component failure and may lead to a fire
that could cause injury or death.
Always
install equipment in locations where heat from the
exhaust system will not damage any hydraulic component.
WARNING:
Being under a raised body can result in serious injury or death should the body unexpectedly
descend.
Never
position yourself or allow others to position themselves under a
loaded
body.
Always
prop the
unloaded
body up using the body prop or body props supplied.
Remember
body props are to be used only on an
unloaded
body. When two props are provided, both props
must be used.
WARNING:
Malfunctioning equipment can cause property damage, injury or death.
Always
have faulty
equipment repaired before continuing its use. Consult the manufacturer if required.
WARNING:
Overloading of a body can cause vehicle or body component damage or an accident which may
cause injury or death.
Never
exceed the gross vehicle weight (GVW) or the gross axle weight
(GAW) rating of your vehicle.
WARNING:
The inadvertent shorting of the vehicle's electrical supply can cause a fire or equipment damage
that could lead to injury or death.
Always
disconnect the vehicle battery prior to installing,
servicing, or repairing the power unit.
WARNING:
Damage to brake lines during equipment installation, or installing bolts or equipment in such a
way that the line will rub and become damaged can lead to brake failure which can cause an
accident and can lead to severe injury or death.
Always
take adequate steps to prevent brake line
damage during installation and isolate brake lines from installed equipment.
WARNING:
Connecting the hoist to a hydraulic system with more pressure (psi) or flow (gpm) than is
recommended by the hoist manufacturer can cause the hoist to fail during the dumping of a load.
This could lead to damage, serious injury, or death.
Be sure
you have the correct pressure and
flow.
