Model LR-26C, LR-623, LR-28A, & LR-2355 Sub-Frame Hoist Installation and Operation Manual
Stock No. 1657499
Page 2 of 25
"HYDRAULIC SYSTEM"
The hydraulic system supplied with a given hoist manufactured by TBEI-Rugby is made up of components
(pump, valves, reservoir, hoses, cylinder, etc.) that are designated to be compatible with each other.
WARNING:
If you substitute hydraulic components, it is your responsibility to
BE SURE
they are compatible
with the other components supplied by TBEI-Rugby. Incompatible hydraulic components may
cause failure of the hoist that, in turn, could damage the vehicle, damage other property, and cause
human injury or death.
All TBEI-Rugby's liability and warranty for a given hoist will be voided, if it is determined by TBEI-Rugby, that
substituted hydraulic components were incompatible with those supplied by TBEI-Rugby.
Several hoist parameters are given in the following table, these parameters are given as a general guide. To
ensure component compatibility, consult TBEI-Rugby.
WARNING:
Adjusting the hydraulic pressure to more than the recommended setting may cause the hoist to fail
during the dumping of a load. This could cause damage, serious injury, or death.
Never
adjust the
pressure on your own. Consult the manufacturer if the hydraulic pressure is in question. Have
only a qualified person set the hydraulic pressure.
Never
adjust the pressure to more than the
recommended amount.
NOTE:
A manual for the hydraulic system is supplied separate from this manual. Refer to the hydraulic
system manual for details on the installation and operation of the hydraulic system.
