12
13
2.3.
REMOVE THE BATTERY
1. Before removing the battery, ensure that the
system is disconnected. Turn the key in the
lock by 90° rotation while tilting the battery
from the upper bracket.
2. Pull the battery from the bracket.
»
Installing the battery:
Install the battery with its contacts onto the
lower bracket and tilt it up to the stop into the
upper bracket, until the lock snaps in audibly.
2.4.
SWITCHING THE DRIVE ON OR OFF
»
you have different ways how you can switch
the eBike-System on and off:
»
press the on/off button of your board compu-
ter when the battery is installed
»
press the on/off button of the eBike battery
(see battery manual)
2.5.
ADJUSTING SUPPORT LEVEL
For the adjustment of the support level, press the „+“ button on the control
unit until the required support level is shown on the display. To lower it, press
the „–“ button.
2.6.
SWITCHING THE LIGHT ON OR OFF
»
Make sure that the Bosch Motor is on.
»
By pressing the for a few seconds,
front and backlight will be turned on.
»
To turn the lights off, press the + button for
a long time.
Detailed information on the operation of the board computer is
found under 4.1.1. Purion board computer.
2.7.
INITIAL ENGAGEMENT OF BRAKE DISCS
Your brake system is delivered with a weak break function, because the
surfaces of the brake discs and pads have not been engaged yet. With a new
Pedelec, and also when changing the brake discs and pads, you should en-
gage the brake discs as follows:
»
Accelerate the Pedelec to approx. 15.53 miles/h (25 km/h)
»
Brake the Pedelec by both brakes until standstill
(avoid to block the wheels!)
»
Repeat this procedure as often as required in order to achieve an optimal
brake performance.
If you force too much the front wheel brake, a hazard of tipping over
exists. Your rear wheel might lift and have you fall over the handlebar.
-> Pull a little less at the left brake lever, or fully release the brake
lever, when you notice that the rear wheel is lifted.
COMMISSIONING
COMMISSIONING
