EN
4. ADHERE TO THE FOLLOWING INSTRUCTIONS
4.1. General instructions
■
Persons who assemble, operate, disassemble or maintain our devices must not be under the influence of alcohol, drugs or phar-
maceuticals that may affect perception and responsiveness.
■
Responsibilities for the operation, maintenance and regulation of the product should be clearly determined and observed so
that there can be no unclear areas of responsibility with regard to safety.
4.2. Indications assembly
■
Disconnect all of the product‘s poles from the mains before installing the product or connecting or removing plugs. Make sure
that the product cannot be switched back on again.
■
Lay cables and lines so that they cannot be damaged and no one can trip over them.
■
Information signs must not be changed or removed.
4.3. Indications Commissioning
■
Make sure that all electrical connections are either used or covered. Commission the product only if it is installed completely.
■
The power switch must always be fully functional and easy accessible!
4.4. Indications during operation
■
Only authorized personnel is allowed to operate the setting mechanisms of the components or parts, under the provision that
the system is used as intended.
■
In an emergency, or if there is a fault, or other irregularities, switch the equipment off and make sure it cannot be switched back
on again.
■
The technical data given on the rating plate must not be exceeded.
5. PRODUCT INFORMATION
Description:
■
Fan for exhaust applications
■
Conveyed exthaust up to 120 °C
■
Backward curved radial impeller
■
A condensate / grease drain is integrated in the bottom of the housing (top discharge). The connection of the condensate drain
is placed at the bottom of the device.
■
Motor outside the air stream (VDI 2052)
■
Thermal motor protection to be connected on site
■
Outdoor installation possible with appropriate accessories
■
Three discharge directions possible: right / left / up
■
Double-skin housing made of galvanized sheet steel with 40 mm thermoacoustic insulation, non-combustible according to DIN
EN 13501-1, building material class A1.
■
The backward curved impeller is made of powder-coated sheet steel.
■
Voltage controllable asynchronous capacitor motor
www.ruck.eu |
5
Summary of Contents for MPS 225 E2 21
Page 17: ...EN NOTES www ruck eu 17...
