6
7
ENGLISH
ENGLISH
Measuring
The cuff
Always measure on the same arm.
Wear the cuff around a bare wrist, about 1-2 cm above the wrist.
The blood pressure monitor should be on the inside of the wrist.
The cuff should not be too loose or tight, but comfortable.
Body posture
1.
Sit down with a straight back, with your
feet to the floor. Don’t cross your legs.
2.
Rest your arm and hand against a surface, e.g. a table.
3.
The cuff should be held at about the same height as your
heart. Use the storage case as a wrist rest if needed.
Measuring
1.
Press START.
2.
The blood pressure monitor seeks zero pressure
before it starts to inflate the cuff. The cuff is
then deflated and the measurement is made.
3.
The monitor calculates blood pressure and pulse
and displays the result. If an irregular heartbeat
is discovered, the heart symbol is also displayed.
The measurement is saved to the memory bank.
The blood pressure monitor shuts down automatically if
no button has been pressed for one minute. Press START
to manually shut down the monitor during or after the
measurement.
Memory function
The blood pressure monitor is equipped with four memory banks, U1- U4. Each bank
can store up to 30 measurements each.
Show saved measurements
Press MEM while in standby mode to show saved measurements. The current
memory bank will blink and the amount of measurements will be displayed.
Keep pressing START to navigate between the four memory groups and pressing
MEM to confirm. The LCD will display the average value of all results in the current
user memory zone. If no result is stored in the current user memory zone, the LDC
will display “0” for blood pressure and pulse rate. The meter will show the average
value of the latest saved measurements taken between 05 - 09 the last seven days
for the current memory bank. If no results are stored within this timespan the display
will show zeros. Press MEM again to show the average value of the latest saved
measurements taken between 18 - 20 the last seven days for the current memory
bank. If no results are stored within this timespan the display will show zeros. Press
MEM once more to show the most recent result, blood pressure and pulse will be
displayed individually and eventual warning symbols. You can keep pressing MEM to
browse through the next separate result. Press the START button to turn the display
off or wait a minute without pressing any buttons.
Delete saved measurements
While watching measurements as described above, press and hold MEM for three
seconds to delete all measurements.
New measurements will replace the oldest measurements if the memory bank already
contains 120 measurements.
