Rubbermaid 5H80, Manual

Page: 6 / 14

12
13
14 15
Install Wall Connector (Q) 5 places. Lubricate dovetails on Side Panel (A) 5 places with liquid soap. Connect Right Back
Panel (D)
onto dovetails of
Side Panel (A).
Align the lap joint between
Left Back
Panel (C) and Right Back Panel (D). Snap Right Back Panel (D) into Back Floor (K).
Using a screwdriver, punch out the screw holes around the perimeter of
Back Gable (R)
22
places. If venting is desired, use the utility knife to cut out vent slots 3 places from inside
of gable before assembly. Connect Back Gable (R) onto the back wall, install Screws (AA)
10 places.
Set the
Left Door Panel (G)
face down. Slide the
Hinge Reinforcement (HR)
into the
hole on the top door pin. The Hinge Reinforcement (HR) will slide in until it is 1/8” above
the end of the door pin.
click
2
1
1
2
1
2
1
2
click
click
click
click
click
Screw Holes
Screw Holes
Screw Holes
Screw Holes
Caution: When installing screws, do not overtighten.
Caution: Make sure the screws hit the targets on the back wall panels.
Caution: Always use gloves when using the utility knife.
BACK GABLE (R)
BACK WALL
SCREW (AA)
A
A
C
C
D
D
D
R
G
K
C D
Q
C
D
AA (10)
HR HR