RTS RTS ISDN 2002, Operator'S Manual

Page: 16 / 51

PAGE 6-16 RTS ISDN 2002 System
6 O P E R A T I O N W I T H A P C
The Windows control software „RTS ISDN 2002“ allows a simple configuration
and control of the system.
6.1 Hardware requirements
The PC must fulfil the following minimum requirements:
•
IBM PC AT, IBM PS/2 or 100% compatible
•
Windows 98, 2000, XP
•
approx. 1,5 MB free hard-disk memory
•
a free serial interface RS-232
•
Micro soft, IBM PS/2 or 100% software-compatible mouse
6.2 Connection of the RTS ISDN 2002 System to a PC
Connect the PC serial interface to the CONTROL (RS232C) interface on the
rear panel of the RTS ISDN 2002 System. Use a RS232 cable (9-pin SUB-D
DIN to 9-pin SUB-D cable).
The serial interface of RTS ISDN 2002 (RS232C) is configured in accordance
with the following parameters by the factory:
•
Data signal
•
19200 Baud
•
8 data bits
•
no parity
The RTS ISDN 2002 System can now be controlled from the PC.
6.3 Installation of the software on the PC
For the installation
1
of the software on the PC, please place the disk in the
drive of the PC. Then start the installation under Windows by selecting the
START button and selecting the sub menu item Command... . Insert into the
command line
a:setup
and select OK button. If your disk drive is not "a", use the corresponding des-
ignation in place of "a", Now follow the remarks of the installation program and
use the recommended directory. As proposed please install a new program
group „RTS ISDN 2002“. In this program group you will find later the symbol
for starting the program as well as a possibility for de-installation of the pro-
gram.
1
Please make a backup copy of the original disk before installation.