5.4.
Adjusting the Dimmer
Rotate the ADDRESS KEY until SERVICE appears in
the menu display, then click the ADDRESS KEY once.
DIMMER will appear in the display. Click the
ADDRESS KEY again. One or more right-pointing
arrowheads will appear. Rotate the ADDRESS KEY to
increase or decrease the brightness of the arrowheads.
Click the ADDRESS KEY to save your change. All
displays will flash asterisks at the new brightness level
and then return to displaying their normal assignments.
6.
OPERATION
6.1.
Panel Mode Selection
The LCP-102 has three panel modes: TRIMS, PAP and
CDP. Select the panel mode as follows:
1.
Rotate the ADDRESS KEY to display SERVICE
then click.
2.
Rotate the ADDRESS KEY to display SET MODE
then click.
3.
Rotate the ADDRESS KEY to display the desired
panel mode then click. Once you have selected a
panel mode, you are ready to select a setup page.
6.2.
Page Select
Within each panel mode, there are four setup pages of
assignments available. Each page lets you setup 16
assignments. You can then switch between pages to view
settings or make changes. Select pages as follows:
1.
Rotate the ADDRESS KEY to display PAGE SEL,
then click.
2.
Rotate the ADDRESS KEY to select PAGE 1, or
PAGE 2 etc., then click. Any assignments that have
already been configured for that page will now
appear in the displays. Otherwise, the displays will
show dashes. You are now ready to setup
assignments on the newly selected page. Refer to the
following paragraphs that apply to the currently
selected panel mode.
6.3.
TRIMS Mode Assignments and
Operation
6.3.1
General
In TRIMS mode, you assign individual ports of the
intercom system to displays and then adjust the input and
output trims. This is the same as adjusting the Analog
Input/Output Gains in ADAMedit or Zeus-edit.
6.3.2
Trims Mode Assignments
1.
Place the LCP-102 in TRIMS mode as previously
described under "Panel Mode Selection".
2.
Select one of the four setup pages as previously
described under "Page Select".
3.
Select one of the 16 assignable displays that is
currently unused by clicking either of the controls
under that display. Then, rotate the control to scroll
through the list of intercom ports. When you locate
the intercom port that you want to assign, click the
control again. The selected intercom port is now
assigned to that display.
4.
Repeat these steps to make further assigments.
5.
To cancel or clear an assignment, click either of the
assigment's controls. The display will go blank.
Click the control once more and the display will
return to showing dashes, indicating no assignment.
6.3.3
Trims Mode Operation
For each assigned display, rotate the upper control under
that display to change the input level. Rotate the lower
control to change the output level. Rotating a control one
notch in either direction will display the current level.
Further rotation will change the level.
6.4.
PAP Mode Asignments and
Operation
6.4.1
General
In PAP mode, you setup IFB's and then adjust the level
from the defined program input to the defined IFB
output.
6
User Manual, LCP-102 Level Control Panel