DKP-4016
Installation 21
Bosch Security Systems, Inc.
Technical Manual
F.01U.308.248
Rev. 03
Connecting the Keypanel to the Intercom
You can configure the OMI using AZedit and IPedit; however, only IPedit can used to configure the keypanel.
Configure the OMI using AZedit
To
configure the OMI to the DKP-4016/4016W using AZedit
, do the following:
1.
From the Status menu in AZedit, select
I/O Cards
.
The I/O Card Status window appears showing a list of installed cards
.
2.
Right-click the
OMI card
you want to configure to the keypanel.
A pop-up menu appears.
3.
From the pop-up menu, select
OMNEO Configuration
.
The OMNEO Configuration window appears.
4.
From the OMNEO card drop down menu, select the
slot number
where the OMI card is located in the frame.
The Device Name field auto-populates with the name of the device.
5.
From the Local Channel drop down menu, select the
channel
you want to use to communicate to your keypanel
across the network.
NOTE:
Channels not already configured to connect to another device appear with an asterisk (*) next to them.
6.
In the Partner Device Name field, enter the
name of keypanel
you want to use to communicate with or select the
Browse icon
to select from a list of devices.
OR
In the Partner IP Address field, enter the
IP Address
of the device to which you want to connect. This field auto-
populates when you select the Device Name.
7.
From the Partner Device Type drop down menu, select the
type of device
to which the OMI card is connecting.
8.
From the Partner Channel drop down menu, select the
channel
on the device to which the OMI communicates.
9.
Once you are completely finished, click
Apply
.
Apply sends all the changes to all the cards in the intercom, or Click Cancel to discard all the changes made.
Add the OMI to the Device Catalog in IPedit
To
add the OMI to IPedit
, do the following:
1.
Open
IPedit
.
2.
From the Device menu, select
Add
.
The Add Devices Window appears, open to the Search tab
.
3.
Select the
OMI card
.
The Add button becomes active
.
4.
Click the
Add button
.
The OMI card appears in the device catalog in the left panel
.
5.
Click the
Done button
.
The Add Devices window closes
.
Summary of Contents for DKP-4016
