7
CHAPTER 2
Configuration and Operation
Address Configuration
Address and Dip Switch Configuration is accomplished via the 16-position rotary switch (Address) and the 8-position DIP
switch, both located on the rear of the ARP-32. See Figure 1 on page 4 for the location of both switches.
Setting Address
A16-position rotary switch is used to select the polling ID. Valid IDs are 1-15. (Note, letters A through F on the rotary switch
represent IDs 10 through 15.) There can be at most one ARP-32 or LCP-102 at any given ID. Use a small flat blade screw
driver to rotate the switch to the desired setting.
Panel Options
The 8-position DIP switch is used to set options as follows
POSITION
DEFINITION
8
Normally OPEN, when CLOSED forces boot download mode.
7
Reserved for diagnostics, must be OPEN.
6
Unused, should be left OPEN
5
Unused, should be left OPEN
4
Disable keypad access, OPEN
3
When CLOSED disables screen saver
2
Unused, should be left OPEN
1
Unused, should be left OPEN
Summary of Contents for ARP-32
