13
7. Reconnect all Ethernet cables and set DIP SW2-1 (or DIP SW2-3) on the Node Processor card
(see Figure 2) back to its OFF position (if changed in step 3) and power-cycle the 3000/06 Node
Processor.
8. Download the user application program (
with the correct I/O Configuration
) from NetArrays.
From the Device Status window, verify that the user application program is running.
9.
For redundant configurations reconnect the Ethernet cables and turn the power on at the “B”, “C”
and “D” Node Processors. The configuration parameters will be transferred to the redundant
processors.
10. For redundant configurations, use again PTDBM application to configure IP addresses for all Node
Processors of the device.
