RTD Embedded Technologies, Inc.
|
www.rtd.com
58
LAN35MH08HR & LAN35ME08HR User’s Manual
while the running configuration is regenerated. These errors are to be expected and may be ignored. They will disappear one a new startup
configuration is saved.
#
delete flash:startup-config<Enter>
#
reload cold<Enter>
% Cold reload in progress, please stand by.
Factory defaults can also be copied from flash to the startup configuration instead of deleted.
#
copy flash:default-config startup-config<Enter>
% Saving 2136 bytes to flash:startup-config
#
reload cold<Enter>
% Cold reload in progress, please stand by.
6.17.2
L
OADING
D
EFAULTS VIA
W
EB
GUI
Under the Web GUI, the factory defaults may be loaded under
Maintenance > Factory Defaults
. This sets all but the current VLAN IP address
to default settings. The same IP addressed used to access the WebGUI originally may be used to access it again.
Figure 44: Factory default configuration using Web GUI
6.17.3
L
OADING
D
EFAULTS VIA
E
XTERNAL
L
OOPBACK
The factory default configuration may be loaded temporarily by connecting Port 1 to Port 2 (GigabitEthernet 1/1 to 1/2) with an Ethernet patch
cable. At boot time, the LAN35Mx08 checks for a loopback on these ports and loads defaults accordingly. The ports must be connected
before the switch it booted. This method of loading defaults is useful for situations where the password has been lost.
To verify that defaults were loaded, use the command
show logging
and look for a
LOOP_BACK_DETECTED
message somewhere in the
list.
A message saying “Loopback detected. Loaded default configuration” is also displayed before logging into the device.
#
show logging<Enter>
Switch logging host mode is disabled
Switch logging host address is null
Switch logging level is notice
Number of entries on Switch 1:
Error : 0
Warning : 0
Notice : 11
Informational: 1
All : 12
ID Level Time & Message
---------- ------------- --------------
1 Informational 1970-01-01T00:00:01+00:00
SYS-BOOTING: Switch just made a cold boot.
2 Notice 1970-01-01T00:00:02+00:00
LINK-UPDOWN: Interface Vlan 1, changed state to down
.
