1
st
: Insert the drawer with the front panel
Ⓞ
into the LEFT of the unit.
2
nd
: Insert the drawer with the front panel
Ⓟ
into the RIGHT of the unit.
3
rd
: Insert and place the adjustable panel
Ⓜ
over the metal pins on the left. You can adjust
the location of the panel according to your preference.
4
th
: Cover the cam locks that are visible at the front of the unit with plastic caps
⑩
.
STEP 27
Assemble the door
Ⓝ
to the unit by joining the hinges
⑮
ⓑ
(on the door) with the hinges
⑮
ⓐ
(on the plastic bases
⑫
) as shown. A little adjustment might be needed if the door
does not close properly, please see instructions below.
DRAWER
Ⓞ
TO THE LEFT.
DRAWER
Ⓟ
TO THE RIGHT.
STEP 26
Hardware:
❿
Caps
6
Pcs
(This view shows the unit in
the normal upright position)
If the door does not close properly, you
can adjust the alignment of the hinges
by adjusting the following screws:
Adjusts the depth.
DONE! Before you start using the unit, make sure that all the screws, bolts, cam locks,
etc. are properly tightened, and read all the warnings in the next page.
P.15
RTA-8807
P.15
