RST 02876, Instruction Manual

Page: 16 / 24

[ CITY ] button to confirm. Use [ ] or [ ] button to select the DST (Daylight Saving Time) ‘ON’ or
‘OFF’, press [CITY] button to confirm.
9. [CLOCK]
- Toggle amongst display for Clock-Sec (HR-MIN-Sec), Clock-day (HR-MIN-Weekday), Calendar
(Date-Month-Year or Month-Date-Year format), alarm time and repeat…
- Press & hold 2 seconds to enter Clock-Calendar or Alarm setting mode.
10. [MODE]
- Press & hold 2 seconds to enter backlight color setting mode when the [ BACKLIGHT ] button is in
AUTO or ON position. The backlight will on for 10 seconds.
11. [RESET]
- To activate system reset to the main unit during abnormal condition which will reset all settings back
to factory values.
12. [BACKLIGHT] slide switch
GETTING STARTED
This Weather Station was designed for easy set up. For best operation, the following steps are
required to be done in the proper sequence.
1. INSERT BATTERIES FOR MAIN UNIT BEFORE DOING SO FOR THE SENSOR UNITS.
2. RECEIVING UNIT CANNOT BE PROGRAMMED MANUALLY UNTIL THE WIRELESS REMOTE SEN-
SOR UNIT REGISTRATION PROCEDURE HAS BEEN COMPLETED.
3. POSITION THE REMOTE UNIT AND MAIN UNIT WITHIN EFFECTIVE TRANSMISSION RANGE,
WHICH, IN USUAL CIRCUMSTANCES, IS 250 FEET.
Note: Windows, walls and competing signals from other wireless appliances will reduce signal
strength. Actual signal distance may vary greatly from location to location. Although the remote
unit is weather resistant, it should be placed away from direct sunlight, rain.
BATTERY INSTALLATION FOR MAIN UNIT
1.
Turn the metal nut anti-clockwise on the bottom of the unit to open and release the battery com-
partment;
2. Insert 4 AA size 1.5V alkaline battery as indicate by the polarity;
3. Push the battery compartment back, turn the metal nut clockwise to lock;
Note: Replace the batteries when the low battery indicator appears on the top-right corner of the
LCD.
WIRELESS REMOTE SENSOR REGISTRATION PROCEDURE
1.
Insert x4 AA batteries first to the main unit, the temperature display shows - - . – While the wave
icon will keep blinking for 2 minutes indicate unit is in sensor searching mode.
2. In a second step, insert the x2 AAA batteries for the sensor unit. The LED on the front panel will
start flashing at a rate of one time per around 2 seconds indicates channel-1 is in use.
3. While the LED is flashing, press once the [ CH ] key will change the sensor channel setting to 2.
Keep toggle on [CH] key can change channel setting up to 5. The LED is blinking at a frequency
to indicate the channel setting. i.e. continuous blinks 2 times indicate channel-2 is selected.
Note: If user does not press any key for 10 seconds, it will exit the channel setting mode and
transmit the RF signal. The main unit will register the temperature reading.
(If the transmitter has the LCD display, the [
°C/ °F ] key will toggle the temperature unit on the
LCD.)
16
Power Supply
Slide switch position Battery Only Battery & Adapter Adapter only
Auto Wave hand in front of the IR sensor to activate backlight for 5 seconds
OFF Disable the backlight function
ON Wave hand in front of
the IR sensor to activate
backlight for 5 seconds
Backlight always on