RST Instruments RSTAR L900 Series, Instruction Manual

Page: 13 / 22

L900 RSTAR Array Radio Series System
Instruction Manual
ELM0077I
RST Instruments Ltd. Page 9
T
ABLE
4-1 D
IAGNOSTIC
D
ATA
F
ILE
D
EFINITIONS
Field Definition
SerialNumber Serial number displayed on the lid of the Node Logger.
BatteryVoltage Battery voltage of the primary cell of the node Data logger. Note that the
lithium metal battery voltage is not correlated with battery life remaining.
More information can be found in the manual of the corresponding data
logger.
Temperature This field is the temperature in degrees Celsius of the data logger. This
does not refer to the thermistor of sensors being read by the data logger.
RRSIL This refers to the signal strength of the response packet received at the
logger node data logger.
RSSIB This refers to the signal strength of the packet received at the RTU.
RxTime The time from the beginning of the RSTAR transmit window that the
logger’s data packet was received.
TxRxStatus This is the status code used to diagnose radio errors.
ReTxCount This refers to the number of times the logger has failed to send a data
packet. Retries are usually caused by lack of signal or noise sources
near the Hub or Node Logger. If this field is increasing steadily, a higher
gain antenna may be required.
Status Diagnostic code for the Node logger
’s program status.
Open Reserved for future use.
4.1.3 File Locations
LoggerNet™ saves downloaded tables in the
C:\Campbellsci\LoggerNet directory
by default. This can be changed in the 'Setup' application. Select the FlexDAQ Hub
logger in the Network tree and navigate to the Data Files Tab.
Be aware that the '*.dat' files generated by
LoggerNet™ are added to on subsequent
data downloads. The files in the C:\Campbellsci\LoggerNet directory should only
be copied and never be edited or renamed.
NOTE: T
HE DOWNLOAD LOCATION WILL RESET TO THE
‘C:\C
AMPBELLSCI
\L
OGGER
N
ET
’
DIRECTORY IF THE TABLES ARE EVER
CHANGED WITHIN THE
F
LEX
DAQ H
UB
L
OGGER BY UPLOADING A NEW
PROGRAM
.
4.1.4 Automatic Data Collection from FlexDAQ Hub Logger
Automatic data retrieval can be set up in the
LoggerNet™ 'Setup' Application for
FlexDAQ Hub Loggers connected to cellular modems or radio infrastructure.