RSP STC350, Product Manual

Page: 29 / 48

M0605-1 ver 2.5 29
3.4 Installation of tool attachment on tool
Action Note
1 Safety Read the safety section (1.1).
2 Mount guide pins Press the guide pin into the
corresponding holes on the tool.
3 Fit tool attachment Lift and fit the tool attachment,
using the guide pin, into its
appropriate guide hole.
4 Mount tool attachment Mount the tool attachment using a
torque wrench with either M8 or
M10 screws:
o
M8-screws are put in from
the tool attachment side to
threaded M8-holes in the
gripper/tool.
o
M10-screws are put in from
the gripper/tool side to the
threaded M10-holes in the
tool attachment.
See tightening torques above.
5 Connect air Connect the air hoses according to
markings.
NOTE! Pneumatic diagram is found
in section 2.1.9.
6 Connect signal cable (TA350-6E only). Connect signal contact Souriau 23P
to the gripper/tool.