RSP Compact Series, Installation And Maintenance Manual

Page: 6 / 22

6 M0416-1 version 3.2
1.2 Safety
1.2.1 General
The integrator installing the tool changer into the system must follow the safety demands stated
in standards and provisions applicable in the country where the tool changer system is to be
installed. The products are all prepared for CE-certification.
The user of the Robot System Products’ tool changer is responsible that law and directives
applicable in respective countries, with regards to safety, are followed. The user is also
responsible to guarantee that all safety devices are installed correctly.
WARNING!
Never carry out service work on a robot that has not been taken out of operation.
See safety information for the robot.
WARNING!
Only perform work on tools attached to the tool changer if the air pressure is safely
switched off.
WARNING!
Be aware that tool changer and tool attachment may cause personal injury and
equipment damage if dropped.
NOTE!
The tool changer shall always be in locked position, also when empty, to avoid
unexpected locking if air pressure is lost.
WARNING!
Electric signals must be disconnected/switched off when docking the tool
attachment. This is to prevent sparking between signal pins and tool attachment.
1.2.2 Explanation of warnings
The warnings in this document are specific to the products in this manual. It is expected that the
user also pay attention to certain notifications from the robot manufacturer and/or the
manufacturers of other components used in the installation.
WARNING!
The warning sign will make you aware that a situation could result in potential
serious injury or damage to equipment.
NOTE!
The note sign will alert you about something important to consider.