4
FITMENT OF THE RSI SMARTCANOPY TO VEHICLE
STEP
FIVE
1. PLACE THE FRONT MOUNTING RUBBER PAD ONTO THE FRONT MOUNT BRACKET LEFT HAND SIDE
& FRONT MOUNT BRACKET RIGHT HAND SIDE.
2.
PLACE THE REAR MOUNTING RUBBER PAD ONTO THE REAR MOUNT BRACKET LEFT HAND SIDE
& REAR MOUNT BRACKET RIGHT HAND SIDE.
STEP
FOUR
1. POSITION THE REAR MOUNT BRACKET LEFT HAND IN THE REAR LEFT HAND CORNER OF THE LOAD BIN.
2. USE TWO M8 X 30 SET SCREWS WITH M8 SPRING WASHERS AND M8 X 2
0
FLAT WASHERS
TO LOOSELY SCREW THE BRACKET TO THE FRONT OF THE LOAD BIN.
4. ONCE THE BRACKET IS IN THE CORRECT POSITION, FASTEN ALL THE SET SCREWS TO 25NM.
5. REPEAT THIS PROCESS IN THE REAR MOUNT BRACKET RIGHT HAND SIDE IN THE REAR RIGHT HAND
CORNER OF THE LOAD BIN.
Moun
t Pad
STEP
SIX
1. PLACE THE CANOPY ONTO THE LOAD BIN.
2.
MAKE SURE THE CANOPY IS IN ITS CORRECT POSITION BY LINING UP THE SLOTS ON THE CANOPY WITH
THE SLOTS ON THE MOUNTING BRACKETS.
3. PLEASE LIFT WITH CAUTION TO PREVENT POSSIBLE INJURY. IT IS RECOMMENDED THAT A MINIMUM OF
FOUR PEOPLE ARE USED TO LIFT THE CANOPY.
Rear Mount Bracket (Left)
M8 X 30 Set Screws
M8 X 20 Fender Washer
M8 Spring Washer
