3
FITMENT OF THE RSI SMARTCANOPY TO VEHICLE
PLEASE ADHERE TO BELOW TO
PREVEN
T
DA
MAGE T
O V
E
HIC
LE AND RSI SMARTCANOPY DURING FITMENT
WAR
NIN
G
!
1. ON
LY USE THE RECOMMENDED
T
OOLS AS INDICATED IN THE
F
ITMEN
T
I
NST
RUC
TION
AB
OVE
2. ONLY USE THE HARDW ARE PROVIDED IN
T
HE
FITMENT KIT OUTLINED ON THE PAGE BEFORE
3. HANDLE ALL RSI SMARTCANOPY FITMENT COMPONENTS WITH CARE UPON UNPACKING.
4. IT IS RECOMMENDED THAT THE MINIMUM OF FOUR PEOPLE ARE USED TO LIFT THE RSI SMARTCANOPY.
5. NEVER USE ACETONE ON PAINTWORK
STEP
ONE
STEP
TWO
1. UNPACK ALL COMP
O
N
E
NT
S & THE HARDWARE KIT FROM PACKAGING; ENSURE THAT EVERYTHING IS
ACCOUNTED FOR AS INDICATED ON PAGE BEFORE
2. WHEN UNPACKING COMPONENTS, PLEASE PLACE THEM ON A PROTECTED SURFACE (E.G. FOAM) TO
ENSURE THAT THE PAINT IS NOT DAMAGED OR SCRATCHED
1. RE
MOVE ANY CAB GUARD, ROLL BAR, TONNEAU COVER ETC.
2.
RE
MOVE THE SPECIFIED TORX SCREW
S.
3. APPLY 5MM FOAM STRIP ALONG TOP SURFACE OF FRONT LIP OF LOAD BIN
STEP
THREE
1. POSITION THE FRONT MOUNT BRACKET IN THE FRONT LEFT HAND CORNER OF THE LOAD BIN.
2. USE TWO M6 X 20 SET SCREWS WITH M6 SPRING WASHERS AND M6 X 16 FENDER WASHERS
TO LOOSELY SCREW THE BRACKET TO THE FRONT OF THE LOAD BIN.
3. USE FOUR M8 X 30 SET SCREWS WITH FOUR M8 SPRING WASHERS AND M8 X 25 FLAT WASHERS
TO FASTEN THE BRACKET TO THE SIDE OF THE LOAD BIN
4. ONCE THE BRACKET IS IN THE CORRECT POSITION, FASTEN ALL THE SET SCREWS TO 25NM.
5. REPEAT THIS PROCESS IN THE FRONT MOUNT BRACKET RIGHT HAND SIDE IN THE FRONT RIGHT HAND
CORNER OF THE LOAD BIN.
Mounting Pad
M6 X 20 Set Screws
Front Mount Bracket Left
M8 X 30 Set Screws
M8 Flat Washer
M8 Spring Washer
