Page 7
Step 8. Drill for Hardware
Drawer front
Drawer box
Oversized holes
Figure 20
Figure 21
Drawer hardware placement guide
Center mark
Tape measure
Drawer front
Pencil
Figure 22
Pencil
Cabinet door
Door hardware
placement guide
(Hardware sold separately)
DRAWER FRONT HARDWARE
PLACEMENT
Hardware Placement Guide provided
Measure the exact width and determine the center point of the
drawer front. Align the drawer hardware placement guide directly
over the center point of the drawer front. For a knob,mark the cen-
ter point. For a handle,mark the outside points that correspond to
the exact width of the desired handle hardware. Drill from the out-
side of the drawer to the inside. A 3/16” drill bit is recommended
to allow for final adjustments for exact alignment (Figure 21).
DOOR HARDWARE PLACEMENT
Hardware Placement Guide provided
Place the handle hardware guide on the corner of the cabinet
door where you would like to have your handle located. Mark
the point on your door that corresponds to the size of your handle
hardware and your door finish. Please note that you must use the
outside holes for the Satin White door finish. Drill through your
marks from the outside of the door to the inside. A 3/16” drill bit
is recommended to allow for final adjustments to exact alignment
(Figure 22).
Every effort was made to provide you with an accurate template,
but we cannot be held responsible for the final print quality.
Always do a visual check prior to actual drilling.