FLANGE MOUNT INSTALLATION
(for kits with Flange option only)
STROBE
POWER SUPPLY
In this configuration, existing strobe extension cables are used to facilitate installation.
WIRING TO EXISTING STROBE CABLES
STROBE BULB
EXTENSION CABLE
(already in vehicle)
NOTE:
Wire colors of LED Kit do not need
to match wire colors of extension cables.
2. Connect LED Kit
connectors to strobe
extension cables.
1. Disconnect strobe
extension cables from
strobe power supply.
3. Remove & Disconnect Strobe
bulbs from extension cables.
4. Insert & Connect LED Ligtheads
to strobe extension cables.
WARNING:
Do not connect LED lighthead directly to strobe
power supply. It will cause damage and void the warranty.
to (+)
to GND
CONTROLLER
NOTE:
Position lighthead so that LEDs are facing the desired direction.
WARNING:
Make sure to use the foams when mounting lightheads.
Supplied sheet
metal screw
Mounting
Flange
Lighthead
Foam
Mounting screw holes
VEHICLE
MOUNTING
SURFACE
to flasher
1.89” (48mm)
Wire hole
0.78” (22mm)
1. Use mounting flange to mark wire and screws holes to drill.
2. Drill marked holes accordingly.
3. Insert lighthead pigtail into wire hole.
4. Place foam, lighthead, and flange in line with the mounting
holes, and secure with supplied sheet metal screws.
The Flange Mount Option enables surface mounting of lightheads
to provide optimum light output to the critical intersection angles.
vehicle top view
