INSTALLATION AND STANDARD WIRING INSTRUCTIONS
1. Do not mount on a surface prone to vibrations.
2. Mounting position: The light should ideally be fixed with the wall
fixing bracket. It is only allowed to be installed according to the
diagram, and not allowed to be installed face up and lateral, air
outlet hole can't face up. (See Fig.1)
3. The distance between the item and the objects must be more
than 1M.Mark the hole positions for fixing bracket onto the wall.
Drill and plug the wall at the marked positions. Screw the fixing
bracket to the wall with suitable screw (not supplied). (See Fig.2)
4. Unscrew the junction box cover and remove diffuser and rubber
seal.
5. Put your mains cable (H05RN-F 3G 1.0mm
2
, not included) into
the junction box through the plastic stud and rubber gasket.
Ensure that the plastic stud is sufficiently tight.
6. Connect the mains wires. (See Fig.3)
7. Replace the junction cover. Take care not to lose the rubber
gasket on the cover.
8. Mount the unit to the wall fixing bracket by replacing the two
bolts. Adjust the light to desired position and tighten the two bolts.
9. The light projection position must be vertical or upwards.
Downwards mounted is forbidden.
10. Undo Screw on the front glass cover and hinge open. Insert
bulb into spring loaded holders. Do not touch the bulb with bare
hand. Close glass cover and tighten. Ensure that all seals and
grommets are secure. (See Fig.4)
ENGLISH
RS, Professionally Approved Products, gives you professional quality parts across all products categories. Our range has
been testified by engineers as giving comparable quality to that of the leading brands without paying a premium price
.
