RS Automation AnyTouch V606e+, Operating Instructions Manual

Page: 5 / 20

5
E
ng
lis
h
Modular Jack (MJ1)
This port is used for such connection as data transfer, temperature controller network, bar code reader, CREC, and V-I/O,
etc. The pin arrangement of modular jack is as follows:
MJ1 Pin No. Signal Contents
1 +SD/RD RS-485 + data
2 − SD/RD RS-485 − data
3 +5V
Output power supply Max. 150 mA
4 +5V
5 SG
Signal ground
6 SG
7 RD RS-232C receive data
8 SD RS-232C send data
Dip Switch Setting
Setting of dip switches is as follows. (The following figure shows the condition when the panel is unpacked.)
When setting DIP switch, turn the power off.
○
Set DIPSW1 to 4 and 8 (not used) to the OFF position.
○
Terminating resistance setting (DIPSW5, 6, 7)
• When connecting the PLC at CN1 via RS-422/485 interface:
− In case using 4-wire connection: set DIPSW5 and 7 to the ON position.
−
In case using 2-wire connection: set DIPSW7 to the ON position.
• For the following connections at modular jack 1, set DIPSW6 to the ON
position.
− Master station for multi-link 2 connection
−
Temperature controller network/PLC2Way connection via RS-485
− Connection with the card recorder CREC (optional)
− Connection with the serial extension I/O V-I/O (optional)
− Connection to the V606e+ unit at the terminal of V-link connection via
RS-485
Mounting Procedure
Mounting Procedure
1. Insert the unit into the mounting panel
(max. thick: 5 mm).
2. Insert four fixtures attached to the V606e+ into the
mounting holes, and tighten them with the locking
screws. (Torque: 0.3 to 0.5 N·m)
3. Mount the gasket so that it will be sandwiched securely
between the unit and the mounting panel.
Mounting Angle
The unit (V606e+) shall be installed within the angle of 0 to 135 degrees.
131
0.5 0
174
0.5
0
Panel cut-out hole
Sheet metal
17.8
10.5 30.0
Dimensions of Fixtures
(unit: mm)
Sheet metal
Mounting hole
Fixture
V606e+
Display
Display
ON
1 2 3 4 5 6 7 8
Not used
Not used
RD terminal resistance of
pin No. 24 and 25 of CN1
Terminal resistance of
MJ1 (modular jack 1)
SD terminal resistance of pin
No. 12 and 13 of CN1