RPS Viper 150 Dirt Bike, Owner'S Manual

Page: 32 / 39

29
Resumption of Service
1. Remove the covering and clean the vehicle. Change the lubricating oil if
the vehicle has been off service for more than 4 months.
2. Drain off the anti-rust solution from the fuel tank, followed by filling fuel
therein to the required level.
3. Prior to driving, test the vehicle at a low speed in a safe place.
Maintenance Routine Diagram
The vehicle should be under good maintenance as specified in the following
table, where:
“I” means: Check, cleaning, adjustment, lubrication and/or replacement
are needed
“C” means: Cleaning is needed.
“R” means: Replacement is needed.
“A” means: Adjustment is needed.
“L” means: Lubrication is needed.
“*” means: This item of maintenance should be carried out at a service
center. It may be also done by the user with reference to this manual provided
special tools and authorized spare parts are used. The user must also be
capable of completing the procedure.
“**” means: This item can only be carried out by an authorized service center
in order to ensure safety.
Notes:
1. Maintenance should be conducted more frequently when the motorcycle
is driven in dusty areas.
2. When the vehicle has exceeded the maximum figures specified in the
table, maintenance should be still cycled according to the intervals of
mileage stated herein.
INSPECTION AND MAINTENANCE
It is very important to inspect and maintain your Viper150 dirt bike regularly.
Follow the guidelines in the chart. The intervals between periodic
services in months are shown. At the end of each interval be sure to
perform the maintenance listed.