- 22 -
M
ICRO
M
AG
-OP-EN
ON-BOARD CHARGER
Charger Specifi cations
•
Output voltage of 24 Volts
•
Output current of 12 amps max
•
Input voltage of 110 Volts/ 60 Hz
(220V/50 Hz available)
•
Automatic shut off circuit
•
Made for Deep Cycle Batteries
DANGER
Explosive hydrogen gas forms when Batteries are
charging. An open fl ame or spark can cause this
gas to explode. Serious personal injury or proper-
ty damage could occur. Only charge the Batteries
in this machine in a well ventilated area.
WARNING
Before you service a battery, always wear face
protection, protective gloves and protective clothing.
Battery acid or battery explosion can cause serious
injuries.
WARNING
The batteries in this machine contain sulfuric acid,
which causes burns to skin. If battery acid con-
tacts clothing or skin, rinse the effected area with
cold water immediately. If battery acid gets on
your face or in your eyes, fl ush the area immedi-
ately with cold water and seek medical attention.
CAUTION
Always use the automatic battery charger provid-
ed by the manufacturer of this machine to charge
the batteries of this machine. It is designed to
charge the batteries at the appropriate rate. If
you must use a different charger, disconnect the
batteries before charging to avoid damage to the
electronic speed controller.
ON-BOARD BATTERY CHARGING (OPTIONAL):
1. Transport machine to a well ventilated area for
charging.
2. Turn the machine off. Tip back tank.
3. Check the water in each battery
(A)
. Do not charge
the machine unless the water is slightly higher than
the plates. If needed, add enough distilled water to
just slightly cover the plates. Be careful not to over fi ll.
Batteries can overfl ow during charging. Replace caps
before charging.
4. Plug the Charger power cord into a grounded standard
wall outlet
(B)
.
5. The green Indicator Light
(C)
will come on and the
Charger will automatically begin charging. When
fi nished, the Charger will automatically shut off as well
as the green indicator light
(check Battery gauge)
.
6. After the Charger has turned off, unplug the Charger
from the wall outlet.
7. Recheck the cell level after charging. If needed, add
distilled water up to the correct level. Be certain to
replace the caps securely and to wipe off the top of the
Batteries with a clean cloth.
WATER LEVEL SHOULD BE
1/8'' ABOVE PLATES
A
B
C
