RPS 3EGF020333, Manual

Page: 30 / 90

3.5 Labelling
The following labelling can be found on and in the TracFeed
®
SFA.
The labels refer to the immediate vicinity in which they are
attached.
WARNING!
Danger if labelling is illegible!
Over time, the labelling may become soiled or oth-
erwise illegible, with the danger that hazards
cannot be detected and the necessary operating
instructions cannot be followed. This results in a
danger of injury.
– Keep all notices in an easily legible state at all
times.
– Replace damaged labelling immediately.
Work on and in the TracFeed ® SFA may only be performed by
trained qualified personnel.
Unauthorised persons must not open the TracFeed ® SFA.
n An earthing or potential equalisation conductor must be con-
nected inside the enclosure. The corresponding bolt is marked
in accordance with Fig. 7.
n The cross sections of the earthing conductors are specified in
EN 60079-0 section 15.3.
Voltage
Fig. 6: Marking of the voltage
Earthing/potential equalisation
clamp
Fig. 7: Marking of the earthing/poten-
tial equalisation clamp
Technical data
Labelling
14.09.2022 TracFeed ® SFA Electromechanical remote motor drive 30