Setting the Flash Unit’s Controls (continued)
3.5mm Synch Cord Input
A synch cord is provided with
your flash unit. The input is a 3.5mm mini plug.
Power Cord Input
110v AC Power Cord input. Use a
grounded outlet.
Tilt Knob
Loosen this knob to tilt (bounce) the entire flash
head.
Remote Button/Remote Display
Indicates the status of
the built-in photocell. Push the remote button to change the
status. Push the button to change the settings.
LED Off: Built-in photocell sensor is off.
LED 1 Lit: Photocell is ON and the unit will flash when
another flash unit fires.
LED 2 Lit: Flash unit will fire on 2nd flash (after preflash).
LED 3 Lit: Flash unit will fire on 3rd flash
LED 4 Lit: Flash unit will fire on 4th flash
LED 5 Lit: Flash unit will fire on 5th flash
Ready LED
Indicates the flash is ready to fire when lit.
Test
To fire the flash without taking a picture, push the Test
button.
Flash Power
Use the Up/Down arrows to control the power
output of the flash. Adjustable in 1/10th f/stop increments.
Power On/Off
Main switch controls power 1 = On, 0 = OFF
Fuse Cover
Remove power cord, and lift the door to
replace fuse. 2 Additional fuses are supplied.
Umbrella Mount
Slide the umbrella shaft into this opening
Mount Knob
Tightens monolite onto a 5/8" post.
- Page 5 -