Unpack the liner inside the pool and unfold from the center toward the walls.
Place an angle of the liner ahead of an angle of the structure and repeat the same operation across the pool.
Insert horizontally the lip of the
liner in the PVC anchorage support.
The liner will be placed immediately
when it is upright.
Make sure the liner is correctly
placed, both on the ground,
as the walls. Adjust the tension
of liner pushing its angle inside
of the angles of the pool.
Make sure the liner is correctly placed and has no folds. If small folds
remain visible, you should, during the filling of the pool help the liner
position correctly. Stop the filling has soon the water level is 30 cm
from the middle of the mouth of Skimfiltre.
Reaching this point of water, and after stopping water filling, place the joint
lock and sealing rings to all embed parts.
IMPORTANT :
Before starting the pool filling, we recommend the utilization of a vacuum cleaner
to remove the air between the wall and the liner. You can use a domestic vacuum
cleaner (without filter). Take out 10 cm. of the liner from the support
and get the tube inside the opening until the height of the pool. Seal the opening
caused by the tube of vacuum with adhesive tape. Put the vacuum to work for
ten minutes and the liner will be laid on the floor and the walls of the swimming pool.
19
Placement of the liner
30