9
Remove the head-harness from the helmet,
then remove the LINK
®
System Side Pads
from the head-harness. Reattach the
ratchet assembly to the head-harness.
Hook the loop of the mounting wire over the
tab on the top of the earmuff mounting clip.
Make sure the angled side of the mounting
wire is towards the back of the helmet.
Squeeze the mounting wire and then push
the wire into the earmuff mounting clip until
it snaps into place.
FIGURE 1.1
FIGURE 1.3
FIGURE 1.2
FIGURE 1.4
SETUP
Repeat these instructions for the other side. Once both earmuffs are attached, reattach the
head -harness. Then put on the helmet and adjust the height of the earmuffs by sliding them
up or down the mounting wire until your ear is in the middle of the cup. Be sure the earmuff
pad is firmly sealing equally all of the way around the ear.