RSL-2702S
15
9.3. mOUNTING
Figure 1
1. Set the laminator to cold by pressing the c/hot button.
2. Lay the decaled image face down on a flat surface.
Carefully peel back and put a crease along the edge of the
release liner (Approximately 1 inch or 25mm, Figure 1).
3. With the image facing up, align the image onto the board.
Press firmly from the center out (Figure 2).
4. With the pressure lever in the open position insert the
leading edge of the mounting board into the nip and close
the pressure lever to the appropriate setting (Figure 3)
5. Flip the image over the upper roller and hold on to the
release liner (Figure 4).
6. Press the run button. Peel back of the release liner at the
same speed as the laminator is running.(Figure 5).
7. Press the stop button once the board has completely
exited the rear of the laminator. Trim the board if necessary
(Figure 5).
Figure 2
Figure 3
Figure 4
Figure 5
