RSC-1650CLT
8
7
7. ROLLER NIP SETTING
It is important to adjust the roller nip settings to the appropriate thickness of the board
being used. Use the guide below to adjust to the correct position.
NO.
Inches
Metric
(mm)
1
Laminating
Laminating
2
0.12"
3
3
0.2"
5
4
0.27"
7
?
?
?
?
?
?
?
?
?
?
?
?
?
?@@@@@@?g?
?@@@@@@?g?
J(M?he?
7Yhf?
@@6Xhe?
@@@)X?h?
?I'@)Xh?
V4@1h?
?@h?
?@h?
?@h?
J5h?
?W.Yh?
?'6KO.Y?h?
?V4@0Yhe?
?
?
?
?
?
OPEN
OPEN
8. USING FOOT PEDAL AND REMOTE CONTROL
USING FOOT PEDAL
Place the foot pedal on the floor in front of the
machine. Once all correct settings are displayed, you
may use the foot pedal to operate the laminator for
“Hands Free Operation.” To activate the machine,
press the foot pedal once and then release. Repeat
to stop the rollers.
NOTE: If you don't want to laminate,please place the pressure lever to the
"Open position(NO.5)".
9. LOADING FILM
Royal Sovereign films are wound with the adhesive side facing the inside of the roll
(adhesive in).
Loading films to upper and lower film shafts:
(See page 5 for assistance with parts identification.)
1. Adjust the auto grip to fit to the film and tighten the
auto grip screw (Figure 1).
2. Remove the upper and lower film shafts from the
machine and load the films (Center the upper and
lower films on the shaft). Note the direction of the
adhesives on the lower and upper films
(Figure 2).
Figure 1
Figure 2
