RSC-1650CL
10
9
Figure 1
1. Lay the decaled image face down on a flat surface.
Carefully peel back and put a crease along the edge of the
release liner (Approximately 1 inch or 25mm, Figure 1).
2. With the image facing up, align the image onto the board.
Press firmly from the center out (Figure 2).
3. Adjust the pressure lever to ensure the proper opening
(Figure 3).
4. Flip the image over the upper roller and hold on to the
release liner (Figure 4).
5. Press the foot pedal once, and then let it go while slowly
pulling the release liner as the board enters the main roller
nip (Figure 5).
Press the foot pedal once again when the board has
completely exited from the rear of the unit.
Trim the board if necessary.
Figure 2
Figure 3
Figure 4
Figure 5
11.2 Mounting
11. THREADING FILM
Figure 1
Figure 2
11.1. Decaling
1. Turn the power switch on (“I” position). The Power
switch is located on the rear left side of the unit.
2. Complete the steps as in the “LOADING FILM”
section (see page 8).
3. Pull the top film down to the bottom of the craft
paper/mounting film.
4. Align and center the craft paper/mounting film to the
top film (Figure 1).
5. Peel the top film off (Figure 2).
)52*8522+8
)52*,/23