Royal Sovereign Quick Ready APL-340U, Owner'S Manual, Page: 6 / 16

6
oPeRATIon
Hot Lamination
Before laminating important or unique documents, always test a pouch through the laminator using a similar document.
1. Place the machine on a flat, sturdy surface and press the power button to turn on the machine.
2. The machine is preset to the 3mil setting. To change the setting, press the temperature control button. The machine will take
approximately 1 minute to warm-up. When the proper temperature is reached, the blinking light will glow steady.
3. Place the item to be laminated into the laminating pouch.
4. Insert the pouch film into the front opening of the laminator. Make sure to place the sealed end of the pouch film in first. All sized
pouches should be placed in the center of the front opening to pass through the sensor.
5. The document or photo will then exit out the back of the machine.
6 .If the item is not completely laminated, repeat step 4.
noTe: After inserting the pouch into the laminator, if the laminated item does not pass through all 4 rollers within approximately
8 seconds the automatic reverse function will turn on sending the item out of the front of the machine. If you need to
reverse an item after it is inserted into the rollers press the reverse button and the item will exit the front opening.
noTe: Laminated items exiting the machine may be too hot to touch.
noTe: Laminated items will be hot and will easily bend. To keep the item flat, place on a flat surface and allow it to cool.
cold Lamination
1. Place the machine on a flat, sturdy surface and press the power button to turn on the machine.
2. Press the temperature setting button until the Cold lamination setting is lit. If the machine was previously used in hot
mode, allow approximately 40 minutes to cool down. When the proper temperature is reached, the light will glow steady.
3. Place the document to be laminated on the non-adhesive side of the cold film with the document face down, sealed end first.
4. Insert the document to be laminated into the front opening of the machine.
5. Remove paper liner from the cold film slowly while the document is being inserted into the machine.
6. The document or photo will exit out the back of the machine.
noTe: After inserting the pouch into the laminator, if the laminated item does not pass through all 4 rollers within approximately
8 seconds the automatic reverse function will turn on sending the item out of the front of the machine. If you need to
reverse an item after it is inserted into the rollers press the reverse button and the item will exit the front opening.