Assembly (continued)
19
Please contact (866) 988-3300 for further assistance.
WWW.ROYALGARDEN.COM
14
ATTACHING THE SUPPORT CHIPS
Attach the support chip 1 (Q) to the right pillar (A1) and the left pillar (A2) using M8X90 combination bolts (HH), M8 washers (II) and
M8 nut (JJ); attach the support chip 1 (Q) to the left beam (B1) and right beam (B2) using M8X90 combination bolt (HH),
M8 washer (II) and M8 nut (JJ), M8X55 combination bolt (FF), M8 washer (II) and M8 nut (JJ), as shown below.
Attach the support chip 2 (R) to the right pillar (A1) and left pillar (A2) using M8X25 combination bolts (EE); attach the support
chip 2 (R) to the top tube A (D3) using M8X60 combination bolts (GG), M8 washers (II) and M8 nuts (JJ), as shown below.
Attach the support chip 2 (R) to the middle pillars (A3) using M8X25 combination bolts (EE); attach the support chip 2 (R) to the
top tubes A (D3) using M8X60 combination bolts (GG), M8 washers (II) and M8 nuts (JJ), as shown below.
Once all of the bolts are in place, fully tighten the bolts.
Use glue (W) to paint on one side of the whole silicone sheet (K), and paste the other side on light tube A (E1) and light tube B (E2).
W
K
R
GG
GG
D 3
EE
A3
JJ
II
II
B1
B2
EE
GG
GG
R
A2 & A1
II
JJ
JJ
II
D3
B1 & B2
JJ
HH
HH
Q
FF
II
II
II
JJ
A2 & A1
B1 & B2
A1
A3
A2
D 3
D 3
D 3
K
B1
B2
NOTE:
More than one person is required to assemble
this step and suggest using a stepladder.
