55
WHEEL REMOVAL / ASSEMBLY
Rear wheel removal
Place the motorcycle on
center stand on a firm and
flat surface.
Note the alignment index
marks in the both side of
swing arm.
Remove wheel spindle from
left side as shown.
Remove the brake hose pipe
from the swing arm clips.
Remove
the
caliper
assembly with bracket by
pulling out from the swing
arm slot.
Place the wooden piece/
card board sheet in
between the brake pads.
Remove the left side
spacer from rear wheel
hub.
Tilt motorcycle to right side
and slide out rear wheel.
Rear wheel reassembly
Ensure the four Cush
rubbers are in position
inside the rear wheel hub.
Tilt motorcycle to right side
and insert the wheel
assembly between the
swing arms.
Position the rear wheel with
cush rubber on the rear
chain sprocket.
Fix the left side spacer in
rear wheel hub.
Remove the wooden piece /
card board sheet in between
the brake pads.
Insert the caliper assembly
with bracket by matching
the slots given in the caliper
and swing arm.
Index mark
Swing Arm Reference
Caliper Slot
Summary of Contents for Bullet 500 2018
