Spindle may need to
be cut to 88mm
19mm
5. Walls to floor
With all the wall panels in position, check they are all sitting square on the floor and secure to the floor using 1 x 63mm screws for each small panel and 2 x 63mm screws
for the larger back and door panels, screw through the wall panel frame and into the floor.
30mm
25mm
4. Door handle and towerbolts
Push the door lock into the rebate on the edge of the right-hand door as shown and secure using 2 x 25mm brass screws. Push the metal handle bar through the door latch
mechanism. Fit a door handle to the metal handle bar on each side of the door and secure them in place using 4 x 30mm black countersunk screws per handle. On the other
door fit the lock plate using 2 x 25mm brass screws. Attach the tower bolts to the inside of the left door as shown using 4 x 19mm round head screws per bolt. Mark where
the tower bolts touch the top and bottom door frame and drill a 12mm diameter hole for each bolt.
Lock plate
attached with
2 x 25mm
brass screws
63mm
6. Roof & corner coverstrips
Lift a large roof panel onto the back of the building and a small roof panel on next to it. Ensure they are resting evenly next to each other and secure together through the
panel frames using 2 x 63mm screws. So that adjustments can be made do not fully tighten these screws until all roof panels are in place. Have a second person holding the
panels up while working round the roof adding the remaining panels. With all the roof panels in position and adjusted as necessary, fully tighten the screws. Attach the roof
panels to the walls using 2 x 63mm screws per panel, screw though the roof panel frame into the top frame of the wall panel. Attach to each of the eight corners two
coverstrip using 4 x 30mm nails per strip.
63mm
63mm
panel frame
Floor
63mm
Important note
So that adjustments can be made do not fully tighten
these screws until all roof panels are in place.
It is recommended to drill pilot holes with a
3mm drill bit for all screws in this section.
3mm
Drill
30mm
Mark where the tower bolts touch the
top and bottom door frame and drill a
12mm diameter hole for each bolt.
12mm
Drill
