© 2021 Rowley
®
Company. All rights reserved. R-TEC Automation
®
is a registered trademark of the Rowley
®
Company, LLC.
10
INITIAL SET UP
CHECK MOTOR DIRECTION
To check travel direction of shade,
press
UP
or
DOWN
on the controller.
Move shade to the desired highest or lowest
position by pressing the
UP
or
DOWN
on the controller.
Quick Press = Step
Long Press = Continuous Travel
To reverse shade direction, hold both
UP
and
DOWN
until the motor responds.
To save upper limit,
hold
UP
and
STOP
.
To save lower limit,
hold
DOWN
and
STOP
.
Damage to shade may occur when
operating motor prior to setting limits.
Attention should be given.
IMPORTANT
Cycle shade up and down prior to setting
limits to settle fabric
IMPORTANT
For FT Motors, the bottom limit should be set ~ 1.38 in. (35mm) below the Ultra-Lock to disengage the auto
lock mechanism when the shade is raised.
IMPORTANT
Reversing motor direction using this method
is only possible during initial set up.
Direction change will not occur if switch is
locked. See
page 11
.
IMPORTANT
After setting limits, motor will automatically
exit from initial set up mode.
IMPORTANT
Motor Response
Approx.
Approx.
Motor Response
or
SET LIMITS
or
or
Initial set up is not complete yet.
5
